Skip to content


Installation

Carefully unpack the device. In the box you should have: 1 x Input Control Elite. 

If you have purchased the version with an micro USB connector you can connect your own Micro USB cable and plug in.

If you have purchased the version without the connector you must first wire in a USB cable to the solder pads. 

Plug the device into your PC and wait for it to be detected.

Download and install the UGT Controller Manager. Follow the onscreen prompts and ignore the “Unverified Publisher” warning.

Once Controller Manager is installed, open it. If your device is plugged in, you will see the message “Ready ”. If your device is not plugged in, you will see the message “Not detected”. You cannot use UGT Controller Manager unless your device is plugged in and detected by Windows.