Device Status

Ready: device is detected
Not Detected if the device is not detected, in this mode you will be unable to use UGT Controller Manager

Firmware: Shows current firmware version.  Click on the button to the right of the firmware version to check for firmware updates and display information about the current firmware.  

Software:  Shows current software version.  Click on the button to the right of the software version to check for updates and display software information.

Reload Settings: Reloads the last saved settings

Reset to Factory: Set all options back to factory settings

Save Settings:  Saves the current config.  Until you click save, none of the changes you have made on the main page or the analog calibration will save